Today's How To'sday by Jennifer Blomquist is awesome! You have made it look so easy - such a great effect!
• • • • •
It’s a new year, and that means a good excuse to try new things. One of the things I’ve recently rediscovered is heat embossing! It always looks so classy on a project and here is another technique you can try to take your heat embossing up a notch with the Emboss Resist technique! It is easy to do, and gives you endless possibilities using your favorite stamps, ink, and embossing powders.
To get started, you are going to need your basics: Versamark ink, embossing powder, heat gun, stamps, and I recommend an embossing buddy (that little fabric pouch in the upper left corner of the photo). It holds some magic cornstarch-like dust that de-statics your projects and keeps stray embossing powder from sticking where you don’t want it.
First, pick your image. I like an image with lots of detail and gaps for color between the raised embossed part of the image. Use the embossing buddy to destatic your paper and them stamp in Versamark. Cover the stamped image with your embossing powder of choice (I like white embossing powder) and heat with your heat gun.
For fun, you can stamp a coordinating image overlapping your heat embossed image. This is your first hint of how the embossing is ink-resistant!
Now, to start inking up your image. Grab a sponge – I like the porous yellow sponges that I can cut into wedges. You can use other sponges to get different densities of ink (the makeup sponges or sponge daubers will give you a darker, more concentrated look). I don’t recommend cotton balls or similar items because you tend to get stray fibers from the cotton ball that pick up ink and put it down where you don’t want it. Take your sponge and tap it on your ink pad to pick up ink. Then, starting from the center of your image, swirl the sponge over your heat embossed image in a circular motion. Keep spiraling out, tapping more ink when necessary, until you have covered your entire embossed image and have the color as dark as you want.
When you are done, you should have your embossed image resisting the color you sponged and the paper picking up the ink you wanted.
Another cool look you can get with this technique is to color in your image using this emboss resist sponging. Just start with your heat-embossed, stamped image. For a more subtle effect, use clear embossing powder.
Take your yellow sponge and squeeze it so the part of the sponge that picks up ink is fairly small. Tap that on your ink pad and color in parts of your stamped image using the swirling technique mentioned above.
Layer your colors until you have the look that you want. You may find that when you are doing this technique that the color you were sponging with seemed to have covered up and stained the embossed area. This is especially common with dark colors of ink. All you have to do is grab a paper towel or tissue and clean off the embossed area by buffing it off. I use the same swirling motion that I sponge with when cleaning off with a Kleenex.
Keep adding color and buffing off the embossed area until you get the contrast you want. Now just take your finished embossed pieces and show them off in a cute card or scrapbook page!
It just takes a little bit of experimenting and a few minutes, and you can end up with a card that has a lot of pop and wow factor. One other tip: I usually do this with dye-based inks. You may get a bit more staining and a longer drying time if you use pigment inks for your sponging. I hope you enjoy trying this out and have lots of fun!
• • • • •
Jennifer, thank you so much for sharing with us today! Such a beautiful card. You are certainly going to stretch my heat embossing with these ideas!
If you have an idea that you would like to share as a How To'sday tutorial, please send your photos and directions to firstname.lastname@example.org.
Have a great day and be sure to stop by tomorrow for Mid Week Mojo sketch Jade #4 from another Guest Designer!